Sanyo PJLINK PLC-WM4500 - Manual (Page 68)

6
Turn off the projector and unplug the AC power cord. Let the
projector cool for at least 45 minutes.
Loosen the screw and open the lamp cover. Loosen 3 screws
of the lamp and pull out the lamp by using the built in handle.
1
Replace the lamp with a new one. Make sure that the lamp is
properly and fully inserted.
4
Connect the AC power cord to the projector and turn on the
projector.
Follow these steps to replace the lamp.
5
P Note:
Be sure to insert the lamp in the correct direction.
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury. Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
CAUTION CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and the Lamp replacement icon appears on the screen and the Lamp replacement icon appears on the screen and
LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE
indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
P Note:
The Lamp replacement icon will not appear when the Display function is
set to Off (p.52), during "Freeze" (p.30) or "No show" (p.29).
Close the lamp cover and secure the screw.
Lamp
Handle
Lamp cover
Screw
Maintenance and Care
New Lamp
Lamp Replacement
When replacing the lamp because it has stopped illuminating,
there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed
on the ceiling, you should always assume that the lamp is
broken, and you should stand to the side of the lamp cover,
not underneath it. Remove the lamp cover gently. Small
pieces of glass may fall out when the lamp cover is opened.
If pieces of glass get into your eyes or mouth, seek medical
advice immediately.
CAUTION
Screws