Sanyo PJLINK PLC-WM4500 - Manual (Page 45)

45
If the projector cannot reproduce proper video image, select a
specific broadcast signal format from among PAL, SECAM, NTSC,
NTSC 4 .4, PAL-M, and PAL-N.
The projector automatically detects an incoming video signal, and
adjusts itself to optimize its performance.
When the Video System is 105i, 100i or 100p, select the
system manually.
If the projector cannot reproduce proper video image, select a
specific component video signal format from among 40i, 575i,
40p, 575p, 70p, 105i, 100i and 100p.
Video jack or S-video jack
The projector automatically detects an incoming video system, and
adjusts itself to optimize its performance.
When Video System is PAL-M or PAL-N, select the system
manually.
Video Input
1
AV System Menu (Video or S-video)
AV System Menu (y, Pb/Cb, Pr/Cr)
Press the MENU button to display the On-Screen Menu. Use
the Point
pq buttons to select Input and then press the Point
u or the SELECT button.
Use the Point pq buttons to select Video, S-video or Computer
1(Component) and then press the SELECT button.
Use the Point pq buttons to select System and then press
the Point u or the SELECT button. Use the Point pq buttons
to select the desired system and then press the SELECT
button.
P Note:
The AV System Menu cannot be selected when selecting
RGB (Scart).
Video System Selection
Auto
y, Pb/Cb, Pr/Cr jacks
Auto
y, Pb/Cb, Pr/Cr SIGNAL FORMAT
PAL/SECAM/NTSC/NTSC4 .4/PAL-M/PAL-N