Sanyo PJLINK PLC-WM4500 - Manual (Page 74)

74
WARNING:
High voltages are used to operate this projector . Do not attempt to open the cabinet .
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the
service center. Specify the model number and explain about the problem. We will advise you how to obtain service.
Appendix
The power is turned off
automatically .
– Power management function runs by initial setting. Check “Setting” section on page 59.
– Do not cover the ventilation slots on the projector. (See pages 4, 6)
– Projector may be used in high ambient temperature environment. Make sure the
temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–40˚C]). (See page 71)
you cannot operate with
the side control . – If the side control is locked at "Key lock" under "Security" of Setting menu, the side
control is not available. Please check “Setting” section on page 61.
The Remote Control does
not work .
– Check the batteries.
– Check if the RC sensor is set properly. (See page 59)
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote control.
Maximum operating range is 16.4’ (5m). (See page 15)
– Make sure that the remote control code conforms to the projector’s code. (See
“SETTING” section on page 58.)
– Unlock the Key lock function for the remote control. (See page 61)
– Wireless remote control does not work when the remote control cable is connected to
the projector. (See page 15)
– Check if the ALL-OFF switch on the remote control is set to “ON.”
– Make sure that the simple mode in the remote control function is set to Off (See page 58).
Wireless mouse function
does not work .
– Check the cable connection between the projector and your computer. (See pages 19,
32)
– Check the mouse setting on your computer.
– Turn on the projector before you turn on the computer.
Indicators blink or light .
– Check the status of the projector with referring to “Indicators and projector condition” on
pages 78-80.
appears on the screen
– Your operation is invalid. Operate correctly.
Unable to unlock the Logo
PIN code lock, Security
key lock or Security PIN
code lock .
– Contact the dealer where you purchased the projector or the service center.
Forget the Logo PIN code
or Security PIN code .
– Contact the dealer where you purchased the projector or the service center.