Sanyo PJLINK PLC-WM4500 - Manual (Page 35)

5
When the video input signal is connected to the
Y-Pb/Cb-Pr/Cr jacks, select y,Pb/Cb,Pr/Cr.
When the video input signal is connected to the
VIDEO jack, select Video.
When the video input signal is connected to the
S-VIDEO jack, select S-video.
When connecting to video equipment, select the type of Video
source in the Source Select Menu.
When the video input signal is connected to the
Y-Pb/Cb-Pr/Cr jacks, select y,Pb/Cb,Pr/Cr.
When the video input signal is connected to the
VIDEO jack, select Video.
When connecting to video equipment, select the type of Video
source in the Source Select Menu.
Video
y,Pb/Cb,Pr/Cr
Video
S-video
Input Selection
When connecting to video equipment, select the type of Video
source in the Source Select Menu.
INPUT 1 MENU
RGB(Scart)
When scart video equipment is connected to the INPUT 1
(ANALOG) terminal, select RGB (Scart).
INPUT MENU
INPUT MENU
y,Pb/Cb,Pr/Cr
1
Press the MENU button to display the On-Screen Menu. Use
the Point
pq buttons to select Input and then press the
Point u or the SELECT button.
Use the Point pq buttons to select the desired input and
then press the Point u button to access the submenu items.
Use the Point pq buttons to select the desired source and
then press the SELECT button.
Video Input Source Selection
Menu Operation
P Note:
• When the video input signal is connected to the Y-Pb/Cb-Pr/Cr jacks,
Y,Pb/Cb,Pr/Cr takes precedence of RGB.
• Y,Pb/Cb,Pr/Cr input can accept the component signal and the analog
RGB signal. When analog RGB signal is not recognized in Y,Pb/Cb,Pr/
Cr input source, set to RGB input manually.
WHEN SELECTING INPUT 1 (COMPUTER INPUT
TERMINALS )
WHEN SELECTING INPUT (5 BNC INPUT jACKS )
WHEN SELECTING INPUT (AV TERMINALS )
HDMI
When the video signal is connected to the HDMI terminal,
select HDMI.