Sanyo PJLINK PLC-WM4500 - Manual (Page 84)

4
The lens of this projector can be replaced with other optional lens. This feature enables you to use the projector for wide
variety of uses.
For installation and replacement of the lens, always contact the sales dealer. The projector lens must be installed or replaced
by well-trained sales or service engineers. Do not attempt to install and replace the lens by yourself as it may cause injury.
Do not hold the lens when carrying or lifting the projector. It may cause serious damage to the projector.
This projector is compliant with PJLink Standard Class 1 of JBMIA (Japan Business Machine and Information System
Industries Association). The projector supports all commands defined by PJLink Class 1 and is verified conformance with
PJLink Standard Class 1.
PJLink is a registered trademark of JBMIA and pending trademark in some countries.
To the sales and service engineers:
For the lens replacement and lens installation, refer to the installation manual of the optional lens. Before replacing and
installing the lens, make sure that you are using the lens with the correct Type No.
Projector Input PJLink Input Parameter
Input 1 RGB (PC analog) RGB 1 11
RGB (Scart) RGB 2 12
HDMI DIGITAL 3 33
Input 2 Video VIDEO 1 21
Y, Pb/Cb,Pr/Cr VIDEO 2 22
RGB RGB 3 13
Input 3 Video VIDEO 3 23
Y, Pb/Cb,Pr/Cr VIDEO 4 24
S-video VIDEO 5 25
Model No.
Standard Zoom Lens : LNS-S20
Long Zoom Lens : LNS-T20
Ultra Long Zoom Lens : LNS-T21
Short Zoom Lens : LNS-W20
Short Fixed Lens : LNS-W21
SCART-VGA Cable : POA-CA-SCART
The parts listed below are optionally available. When ordering those parts, specify the item name and Model No. to the sales
dealer.
Appendix
Optional Parts
Pj Link Notice
Lens Replacement