Sharp SF-1120 - Manual (Page 22)

6 Hold the hand carry strap of the developing unit and insert it into
the copier fully to the bottom.
7 Close the developing unit lever and close the front cabinet.
With the above procedure, setting of the developing unit is com-
pleted.
6. Toner density sensor level adjustment
Turn on the copier power switch.
A. Developing unit level adjustment
1 Execute simulation 25.
2 After 3 minutes, simulation 25 is completed.
(Note) If the simulation is terminated halfway, automatic reading
is not performed. Do not terminate it halfway.
3 Cancel simulation 25 with the CA key.
7. Accessory installation
A. Copy tray installation
Install the copy tray to the paper exit section on the left side of the
copier.
8. Toner supply
1 Open the front cover.
2 Pull down the developer unit lock lever and pull the developer unit
out slowly unit it stops.
Developing unit
Grip
Hand carry strap
Developing unit lever
Front cabinet
0 C 2
5 2
Copy tray
4 – 5