Samsung Evergreen a667 - Manual (Page 109)

Tools 104
Voice Recognition
Nuance Voice Recognition software is an advanced speech
recognition software used to activate a wide variety of functions
on your phone. Nuance software automatically voice activates
(up to 1,000 contacts) for voice dialing and searching. No
pre-recording or training needed. Speak a contact name
naturally to dial, and use your voice to look up contacts, launch
applications and navigate phone menus.
1. Press Menu ➔ My Stuff ➔ Tools ➔ Voice Recognition.
2. At the voice prompt, say a command. Following is a list of
available commands.
Note: This list of voice commands briefly displays.
Say a Command Options
• Call : dials a name or number listed in your contact list.
If multiple numbers exist (i.e. home, work, or other) say the name and
the number type (location).
• Send Message : displays the Create Text Message
screen.
• Lookup : allows you use a voice command to locate and
display contact information stored in the Contacts list.
• Go To : accesses all the features of your phone if they are
activated, such as: Voice mail, Contacts, Ringtones, Calendar, Tasks,
and Browser.
• Check : lets you check your phone's status in the same report
(Status, Messages, Missed Calls, Time, Signal strength, Network,
Battery, My Phone Number, and Volume).
While the Say a Command screen displays you have two options:
• Tutorial: provides examples of how to use the voice commands.
• Settings: lists the settings for voice command software such as:
Confirmation, Adaptation, Audio Modes, Speakerphone, and About.
If the phone does not recognize your command the Command not
recognized screen displays with two options:
• Tutorial: provides instructions on how to use voice commands.
• Restart: press and try the command options again.
Speak clearly when giving your command. There is no need for
you to speak slowly or with added emphasis. The voice
recognition software has been optimized to understand your
speech in its natural form. If it does not recognize your command
after a few seconds, a voice prompt asks you to repeat the
command. If it does not recognize your command again, the
following message displays “Sorry, no match found,” and voice
recognition turns off.