SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 711)

35-1
C
HAPTER
35
IP I
NTERFACE
C
OMMANDS
An IP address may be used for management access to the switch over your
network. An IP address is obtained via DHCP by default for VLAN 1.
You can manually configure a specific IP address, or direct the switch to
obtain an address from a BOOTP or DHCP server when it is powered on.
You may also need to a establish a default gateway between this device and
management stations that exist on another network segment.
Basic IP Configuration
This section describes commands used to configure an IP address for the
switch
Table 35-1 Basic IP Configuration Commands
Command Function Mode Page
ip address Sets the IP address for the current
interface IC 35-2
ip default-gateway Defines the default gateway through which
this router can reach other subnetworks GC 35-3
ip dhcp restart Submits a BOOTP or DHCP client
request PE 35-4
show ip interface Displays the IP settings for this device NE,
PE 35-5
show ip redirects Displays the default gateway configured
for this device PE 35-5
show arp Displays entries in the ARP cache PE 35-6
ping Sends ICMP echo request packets to
another node on the network NE,
PE 35-6