SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 563)

LACP
25-5
Example
The following shows LACP enabled on ports 46-48. Because LACP has
also been enabled on the ports at the other end of the links, the show
interfaces status port-channel 1 command shows that Trunk1 has been
established.
Console(config)#interface ethernet 1/46
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/47
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/48
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type: 1000T
Mac address: 00-30-F1-D4-73-A4
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full
Flow control: Disabled
Port security: Disabled
Max MAC count: 0
Current status:
Created by: Lacp
Link status: Up
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/46, Eth1/47, Eth1/48,
Console#