SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 385)

F
ILE
M
ANAGEMENT
C
OMMANDS
19-15
When downloading runtime code, the destination file name can be
specified to replace the current image, or the file can be first downloaded
using a different name from the current runtime code file, and then the
new file set as the startup file.
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from a
TFTP server. The configuration file can be later downloaded to restore
switch settings.
The configuration file can be downloaded under a new file name and then
set as the startup file, or the current startup configuration file can be
specified as the destination file to directly replace it. Note that the file
“Factory_Default_Config.cfg” can be copied to the TFTP server, but
cannot be used as the destination on the switch.
Table 19-6 Flash/File Commands
Command Function Mode Page
copy Copies a code image or a switch configuration
to or from flash memory or a TFTP server PE 19-16
delete Deletes a file or code image PE 19-19
dir Displays a list of files in flash memory PE 19-20
whichboot Displays the files booted PE 19-21
boot system Specifies the file or image used to start up the
system GC 19-22