SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 687)

IGMP Q
UERY
C
OMMANDS
33-9
IGMP Query Commands
This section describes commands used to configure Layer 2 IGMP query
on the switch.
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to
disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• IGMP snooping querier is not supported for IGMPv3 snooping (see
ip igmp snooping version, page 33-4).
• If enabled, the switch will serve as querier if elected. The querier is
responsible for asking hosts if they want to receive multicast traffic.
Table 33-3 IGMP Query Commands
Command Function Mode Page
ip igmp snooping querier Allows this device to act as the
querier for IGMP snooping
GC 33-9
ip igmp snooping
query-count Configures the query count GC 33-10
ip igmp snooping
query-interval Configures the query interval GC 33-11
ip igmp snooping
query-max-response-time Configures the report delay GC 33-11
ip igmp snooping
router-port-expire-time Configures the query timeout GC 33-12