SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 581)

SHOW RATE
-
LIMIT COS
27-5
show rate-limit cos
This command displays the output rate limit for CoS priorities.
Command Mode
Privileged Exec
Command Usage
If no rate limit is set, this command displays a value of “0” for the
corresponding interface.
Example
The following example shows that the rate limit set in the preceding
example for CoS priority class 0 affects both priority class 0 and 3, which
are now effectively treated as priority class 1. Table 27-2 on page 27-4
illustrates the priority mapping.
Console#show rate-limit cos
Interface Cos Ratelimit
--------- --- ---------
Eth 1/1 0 50
Eth 1/1 1 0
Eth 1/1 2 0
Eth 1/1 3 50
Eth 1/1 4 0
Eth 1/1 5 0
Eth 1/1 6 0
.
.
.