SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 380)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
19-10
Example
System Mode Commands
This section describes command used to configure the switch to operate in
normal mode or QinQ mode.
system mode
This command sets the switch to operate in QinQ mode. Use the no form
to restore the default setting of normal operating mode.
Syntax
system mode qinq
no system mode
qinq – Sets the switch to QinQ mode, and allows the dot1q tunnel
port to be configured. For an explanation of QinQ, see
“Configuring IEEE 802.1Q Tunneling” on page 30-24.
Console#show version
Unit1
Serial Number: 0000E8900000
Hardware Version: R01
EPLD Version: 0.01
Number of Ports: 29
Agent (Master)
Unit ID: 1
Loader Version: 1.0.0.1
Boot ROM Version: 1.0.0.7
Operation Code Version: 1.0.1.5
Console#
Table 19-4 System Mode Commands
Command Function Mode Page
system mode Configures the switch to operate in normal
mode or QinQ mode GC 19-10
show system mode Displays the switch system mode GC 19-11