SMC Networks SMC TigerAccess SMC7824M/FSW - Manual (Page 646)

C
LASS OF
S
ERVICE
C
OMMANDS
31-2
Priority Commands (Layer 2)
This section describes commands used to configure Layer 2 traffic priority
on the switch.
Table 31-2 Priority Commands (Layer 2)
Command Function Mode Page
Global Priority Settings
queue mode
Sets the queue mode to strict priority or
Weighted Round-Robin (WRR) GC 31-3
show queue mode Shows the current queue mode PE 31-4
Port-based Priority Settings
switchport priority
default
Sets a port priority for incoming untagged
frames IC 31-4
queue bandwidth Assigns round-robin weights to the
priority queues IC 31-6
queue cos-map Assigns class-of-service values to the
priority queues IC 31-7
show queue
bandwidth Shows round-robin weights assigned to
the priority queues PE 31-8
show queue cos-map Shows the class-of-service map PE 31-9
show interfaces
switchport Displays the administrative and
operational status of an interface PE 24-16
VLAN-based Priority Settings
vlan priority
Modifies the priority for frames entering a
VLAN through a selected interface IC 31-9
show vlan based
priority Displays the modified priority for frames
entering a VLAN PE 31-10