Sharp SL-5500 - Manual (Page 109)

104 Settings
Note: The Automatic-receiving mode consumes more battery power than the
Manual-receiving mode, because the IR port is always in receiving mode
to be set to Manual-receiving mode, when the IR port is not in use.
Transferring data between the same models (SL-5500)
Receiving data in Manual mode
1.
(in the receiving unit)
In the Settings folder of the Home screen, tap the “Beam Receive” application
icon.
The Beam Receive screen appears.
2.
Tap the Manual radio button and then tap “Start” to enter receiving standby
mode.
3.
Point the IR ports of both units at each other.
4. (in the sending unit)
To send an application entry
Open the Detail screen you want to send.
Then, tap the “Data” menu and then tap “Send by beam…”.
The entry will be transferred.
To send a document file
Tap and hold the desired document file icon in the Documents folder, and then
on the Details screen that appears, tap “Beam”.
The document file will be transferred.
(in the sending unit)
To cancel sending on the way, tap “Cancel”.
(in the receiving unit)
After a while, the Beam Receive screen turns to the infrared receive screen.
00.Cover.book Page 104 Monday, January 21, 2002 5:47 PM