JVC UX-J99DVD - Manual (Page 74)

71
English
There are three timers available—Recording Timer, Daily Timer and
Sleep Timer.
• Before using these timers, make sure the built-in clock is set
correctly (see page 10).
• When using the tuner as the source, preset stations in advance (see
page 14).
Using Recording Timer
With Recording Timer, you can make an unattended recording.
• You can set Recording Timer whether the unit is turned on or off
(on standby).
• To correct a mis-entry any time during the setting process, press
CANCEL.
• To exit from the timer setting during the process, press CLOCK/
TIMER repeatedly until the source indication appears.
How Recording Timer actually works
The unit automatically turns on, muting the volume, and starts
recording on the MD or on the tape when the start time comes.
Then, when the shut-off time comes, the unit automatically turns off
(on standby).
Recording Timer works only once, but the timer settings remain
stored in memory until you reset them or unplug the AC power cord.
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly until
“REC TIMER” appears on the display.
The (timer) indicator lights up and the REC (recording timer)
indicator starts flashing on the display.
• Each time you press the button, the timer changes as follows:
* Source indication appears only when the unit is turned on.
The hour digits of the start time start flashing.
2
Set the start time.
(1) Press cursor 3/2 repeatedly to
adjust the hour.
(2) Press SET.
The minute digits start flashing.
Using the Timers
REC TIMER
(Recording Timer on/off)
DAILY TIMER
(Daily Timer on/off)
DAILY TIMER
(Daily Timer setting)
Clock setting Source indication*
(canceled)
REC TIMER
(Recording Timer setting)
(3) Press cursor 3/2 repeatedly to adjust
the minute.
(4) Press SET.
The hour digits of the shut-off time start flashing.
3
Set the shut-off time.
(1) Press cursor 3/2 repeatedly to
adjust the hour.
(2) Press SET.
The minute digits start flashing.
(3) Press cursor 3/2 repeatedly to
adjust the minute.
(4) Press SET.
The source name flashes on the display.
4
Select the source to record from.
(1) Press cursor 3/2 repeatedly to select
the source.
• Each time you press the button, the
source changes as follows:
(2) When you select “FM” or “AM,” press SET, then select a
preset number by pressing cursor 3/2.
• If you select “FM – –” or “AM – –,” the station is set to the
last tuned station.
When you select “AUX” or “AUX-DIGITAL,” set the
timer function of the external component as well.
(3) Press SET.
A device to record onto flashes on the display.
Ex.: When you set shut-off time to 13:00.
REC
Ex.: When you set start time to 11:30.
FM AM AUX
AUX-DIGITAL
REC
REC
EN71-75_UX-J99DVD[UB]5.p65 03.12.12, 11:06 PM 71