JVC UX-J99DVD - Manual (Page 46)

43
English
To remove the cassette, press 0 (TAPE eject) on the unit.
Tape operation indicators go off.
Pressing 0 (TAPE eject) button also turns on the unit if the cassette is
unlocked.
DO NOT press 0 (TAPE eject) during tape play.
To play both sides—Reverse Mode
You can set the deck to play just one side or both sides of a tape
once, or both sides continuously.
Press REV.MODE.
• Each time you press the button, Reverse Mode
changes as follows:
: Plays back only one side (front or reverse).
: Plays back the front and reverse sides once.
: Plays back both front and reverse sides continuously.
When you eject the cassette, Reverse Mode changes to automatically.
To change the information shown on the display
On the remote control ONLY:
Press DISP/CHARA.
Each time you press the button, the information on the
display alternates between the source indication and
the clock indication.
• The use of C-120 or longer tape is not
recommended, since characteristic
deterioration may occur and this tape easily
jams in the pinch rollers and the capstans.
• You can also play back type II and type IV
tapes; however, the sound quality (tone) may
not be reproduced properly.
To prohibit cassette ejection—Cassette Lock
You can prohibit cassette, disc, and MD ejection from the unit,
and lock the cassette.
See “Prohibiting Disc Ejection—Disc Lock” on page 23 for
details.
Playing Back a Tape
You can play back type I tapes.
1
Insert a cassette into the cassette loading slot with
the exposed part of the tape facing left.
• When the unit is turned on, the TAPE indicator appears on the
display.
• If you insert the cassette when the unit is in tape mode, “TAPE
LOAD” appears on the display.
2
Press TAPE 2 3.
Playback starts (if the unit has been on standby, the
unit automatically turns on).
To change the tape direction, press the button again.
• Each time you press the button, the tape direction changes as
follows:
: Plays the front side.
: Plays the reverse side.
When the tape plays to the end, the deck automatically stops if
Reverse Mode is set to
or . (See “To play both sides—
Reverse Mode” on the right column.)
To stop during play, press 7.
To fast-wind the tape forward or reverse, press ¢ or 4.
The tape direction indicator ( 3 or 2) starts flashing rapidly on the
display.
Tape direction indicator
Tape direction
Playing Back a Tape
Reverse Mode indicator
TAPE
TAPE indicator
TAPE
Tape operation indicators
TAPE
Remains lit
TAPE
Ex.: Fast-winds the tape forward.
Ex.: Fast-winds the tape reverse.
EN43-44_UX-J99DVD[UB]5.p65 03.12.12, 11:04 PM 43