JVC UX-J99DVD - Manual (Page 67)

64
English
5
Press SET when you find the point
where you want to divide the track.
“POSIT. (position) 0” appears on the display, and the unit
repeats the selected point—a 3-second period following the
dividing point.
• If the loaded MD has 254 tracks, “DISC FULL” will appear
(see “MD limitations” on page 88) and you cannot go to the
following steps.
• If the dividing point is satisfactory, go to step 7 .
If not, go to the next step.
• To cancel the setting, press CANCEL, then repeat from step 4 .
6
Press UP ¢ or DOWN 4 to
precisely adjust the dividing point.
When you stop pressing the button, the unit repeats the newly
selected dividing point.
• You can shift the dividing point up to ±128. This range (±128)
corresponds to approximately ±8 seconds* from the original
point (position 0).
* When the recording length mode of the selected track is “SP:”
For “LP2,” it is approximately ±16 seconds, and for “LP4”
approximately ±32 seconds.
• When you find the correct position, go to the next step.
• To cancel the setting, press CANCEL, then repeat from step
4 .
7
Press SET.
8
Press ENTER.
“EDITING” appears and the REC (MD recording)
indicator flashes on the display. Then “WRITING”
flashes while editing you have made is being recorded
on the MD.
To join the divided tracks, see the JOIN function on page 65.
In the following examples of track editing, the process is explained
from the very first—that is, inserting a disc. You can also edit an
MD during playback (in Normal Play).
Dividing a Track—DIVIDE
This function allows you to divide one track into two separate
tracks. It is useful, for example, when you want to add track marks
at a certain point within a track or if you want to separate a
recording.
When the original track has a title, two separate tracks are
reassigned the same title as the original track in the same group (if
the original track is belonged to a group).
Once a track is divided, the other tracks are renumbered.
• To stop any time during the editing process below before step
8 ,
press TITLE EDIT.
1
Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:
2
Press TITLE EDIT repeatedly until
“DIVIDE ?” appears on the display.
• If the loaded MD has no track, “DIVIDE ?” will not appear on
the display.
• If you want to stop this editing process, press CANCEL.
3
Press SET.
The first track on the MD starts playback repeatedly.
4
Press UP
¢ or DOWN 4 to
select the track you want to divide.
• You can also select the tracks using the number buttons. In this
case, the selected track starts playing repeatedly.
Ex.: When adjusting the point by –103.
Ex.: When track 12 is selected.
EN63-70_UX-J99DVD[UB]5.p65 03.12.12, 11:06 PM 64