JVC UX-J99DVD - Manual (Page 14)

11
English
• If “CANNOT LISTEN” appears on the display
During high-speed recording, you cannot listen to any source, and
therefore, cannot adjust the volume level.
• For private listening
Connect a pair of headphones to the PHONES jack. No sound comes out
of the speakers. Be sure to turn down the volume level before connecting
or putting on the headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise,
the sudden blast of sound can damage your
hearing, speakers and/or headphones when you
turn on the unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is on standby (off).
To turn down the volume level temporarily
On the remote control ONLY:
Press FADE MUTING.
The volume level gradually decreases to “VOLUME MIN.”
To restore the sound, press FADE MUTING again.
• Pressing AUDIO VOL + or turning VOLUME + / – control
clockwise (to +) on the front panel also restores the sound.
Reinforcing the Bass Sound
The richness and fullness of the bass sound is clearly maintained
regardless of how low you set the volume level
—Active Hyper Bass Pro (AHB PRO).
• This function only affects the playback sound, and does not affect
your recording.
• This function also affects the sound from headphones.
To get the effect, press AHB PRO.
The AHBPRO indicator also lights up on the display.
• Each time you press the button, the Active Hyper Bass Pro effect
turns on and off.
To cancel the effect, press AHB PRO repeatedly until “AHB PRO
OFF” appears on the display.
The AHBPRO indicator goes off.
To turn off the unit automatically (Auto Standby)
Using Auto Standby, the unit automatically turns itself off (on
standby) if no operation is done for about 3 minutes except when
playing back and when FM or AM is selected as the source.
If an operation is done within this 3-minute period, Auto Standby is
canceled temporarily even though no sound comes in.
• You can also turn off the unit automatically by using the Sleep
Timer. (See page 75.)
On the remote control ONLY:
To activate Auto Standby, press A.STANDBY.
“A.STANDBY ON” and the AUTO STANDBY indicator
appear on the display.
• When no sound comes in, the AUTO STANDBY indicator
starts flashing on the display. About 5 seconds before the
unit turns itself off (on standby), “AUTO STANDBY”
starts flashing on the display.
To deactivate Auto Standby, press A.STANDBY again.
“A.STANDBY OFF” appears on the display for a while and the
AUTO STANDBY indicator goes off.
Adjusting the Volume Level
You can adjust the volume level only while the unit is turned on.
The volume level can be adjusted between “VOLUME MIN,”
“VOLUME 1”– “VOLUME 40,” and “VOLUME MAX.”
• The volume level has no effect on recording.
On the remote control:
To increase the volume level, press AUDIO VOL +.
To decrease the volume level, press AUDIO VOL –.
• When you press and hold either button, you can change
the volume level continuously.
On the unit:
To increase the volume level, turn the
VOLUME + / – control clockwise.
To decrease the volume level, turn the VOLUME
+ / – control counterclockwise.
AUTO STANDBY indicator
STANDBY AUTO
AHBPRO indicator
AHBPRO
AHB PRO
VOLUME +
–
Basic and Common Operations
(Continued)
(On the remote control) (On the unit)
EN10-12_UX-J99DVD[UB]5.p65 03.12.12, 11:02 PM 11