JVC UX-J99DVD - Manual (Page 42)

39
English
Programing the Track Playing Order
—Program Play
You can arrange the order in which the tracks play before you start
playing. You can program up to 32 tracks.
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 3 again.
1
Load an MD.
• If the current playing source is not “MD,” press MD , then
7 before going to the next step.
On the remote control ONLY:
2
Press PLAY/FM MODE repeatedly
until “PROGRAM” appears on the
display.
The PRGM indicator lights up on the display.
• Each time you press the button, play mode changes as follows:
If a program has been stored in memory, the program is called
up.
3
Press the number buttons to
select the tracks.
Ex.: For track number 5, press 5.
For track number 15, press +10,
then 5.
For track number 20, press +10,
then 10.
For track number 30, press +10, +10, then 10.
4
Repeat step 3 to program other tracks you want.
PRGM (program) indicator
Last programmed
track number
Step number
Total playing time
5
Press MD .
The tracks are played in the order you have
programed. Program Play ends when all the
programed tracks are played once (when Repeat
Play is not activated).
To stop during play, press 7.
The program you have made is still stored in the memory.
To exit from Program Play, before or after play, press PLAY/FM
MODE repeatedly so that the unit enters another play mode
(Random Play, Group Play, or Normal Play).
The PRGM indicator goes off.
• Turning off the unit or ejecting MD also cancels Program Play
and changes the play mode to Normal Play. The program you
have made will be erased.
To check the program contents
Before playing, you can check the program contents
by pressing
¢ or 4.
• ¢: Shows the programed tracks in the programed order.
• 4: Shows them in the reverse order.
To modify the program
On the remote control ONLY:
Before playing, you can erase the last
programed track by pressing CANCEL.
Each time you press the button, the last programed track is erased
from the program.
To add tracks in the program before playing, simply select the
track numbers you want to add by following step
3 in Program Play.
To erase the entire program, press 0 (MD eject) on the unit to
eject the MD.
• The program will be erased when you turn off the power, unplug
the AC power cord or a power failure occurs.
• If you try to program a 33rd track
“MEMORY FULL” will appear on the display.
• If your entry is ignored
You are trying to program a track that does not exist on the MD (for
example, selecting track 14 on an MD that only has 12 tracks).
• If the total playing time is 2 hours 30 minutes or more
The total playing time on the display will not be shown. “– – : – –” will
appear.
MD PRGM
MD PRGM
MD RANDOM
(Random Play)
MD GROUP
(Group Play)
MD NORMAL
(Normal Play)
MD PROGRAM
(Program Play)
Playing Back an MD
(Continued)
(On the remote control) (On the unit)
¢ UP 4 DOWN
EN37-42_UX-J99DVD[UB]5.p65 03.12.12, 11:04 PM 39