JVC UX-J99DVD - Manual (Page 16)

13
English
Setting the AM Tuner Interval Spacing
Some countries AM channel intervals are set to 9 kHz apart, and
some countries use 10 kHz apart.
When shipped, the built-in AM tuner is set to 9 kHz spacing. You
can change the channel interval to 9 kHz or 10 kHz spacing.
• The last selected source must be “AM” in order to perform the
following operation.
Be sure that the unit is turned off (on standby), but is plugged
into a wall outlet.
On the unit ONLY:
1
Select the AM channel intervals.
• To set the AM tuner to the 10 kHz spacing, press
(standby/on) while holding ¢ UP.
• To set the AM tuner to the 9 kHz spacing, press
(standby/on) while holding 4 DOWN.
2
Press .
The unit tunes in to 530 kHz (or 531 kHz).
When you change the AM channel interval spacing
The preset stations you have set (both FM and AM) will be erased. In this
case, preset stations again. See “Presetting Stations” on page 14.
Tuning in to a Station
1
Press FM/AM/AUX (or FM/AM on the unit) to
select either “FM” or “AM.”
The unit automatically turns on and tunes in to the previously
received station—either FM or AM.
• Each time you press the button, the band changes as follows:
On the remote control:
* For operating the external equipment, see page 44 and the manuals
supplied with it.
On the unit:
2
Press and hold UP
¢ or DOWN 4 for more
than 1 second.
• UP ¢: Increases the frequencies.
• DOWN 4: Decreases the frequencies.
The unit starts searching for stations and stops when a station of
sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the STEREO indicator
lights up on the display (only when the reception is good).
To stop during searching, press UP ¢ or DOWN 4.
When you press UP ¢ or DOWN 4 repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive, you can
change the FM reception mode to improve the reception.
On the remote control ONLY:
Press PLAY/FM MODE.
The MONO indicator lights up on the display.
To restore the stereo effect, press PLAY/FM MODE again so that
the MONO indicator goes off. In stereo mode, you can hear stereo
sound when a stereo program is broadcast.
• The STEREO indicator lights up only when the reception is
sufficient.
Listening to FM and AM Broadcasts
(On the remote control) (On the unit)
(On the remote control) (On the unit)
FM AM
FM AM
AUX * AUX–DIGITAL *
AUX
FM/AM
¢ UP 4 DOWN
+
+
¢ UP
4 DOWN
EN13-14_UX-J99DVD[UB]5.p65 03.12.12, 11:02 PM 13