JVC UX-J99DVD - Manual (Page 36)

33
English
2
Press cursor
∞/5 repeatedly to
select a parameter you want to
adjust.
Adjust the parameters so that the picture you
are viewing appears as you prefer.
GAMMA Adjust if the neutral color is bright or dark.
The brightness of dark and bright portions is
maintained.
Available range: OFF, 1 (darkest) to 3
(brightest)
BRIGHTNESS Adjust if the picture is bright or dark as a
whole.
Available range: –8 (darkest) to +8
(brightest)
CONTRAST Adjust if the far and near position is
unnatural.
Available range: –7 to +7
SATURATION Adjust if the picture is whitish or blackish.
Available range: –7 (most blackish) to +7
(whitest)
TINT Adjust if the human skin color is unnatural.
Available range: –7 to +7
SHARPNESS Adjust if the picture is indistinct.
Available range: –8 to +8
3
Press ENTER.
VFP parameters list disappears, and the following
pop-up window for the selected item appears on
the TV.
Ex.: When “GAMMA” is selected.
4
Press cursor ∞/5 repeatedly to
select the value, then press
ENTER.
Your adjustment is stored and the current
VFP parameter list appears again.
5
Repeat steps 2 to 4 to adjust other parameters.
To turn off the VFP setting screen
Press VFP.
To activate your setting
Press VFP, then press cursor
3/2 repeatedly to select “USER1” or
“USER2.”
If no operation is done for about 10 seconds
The VFP setting screen disappears.
OFF
USER1
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
+0
+0
+0
+0
+3
Changing the VFP Setting
The VFP (Video Fine Processor) function enables you to adjust the
picture based on the picture tone, or personal preference.
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
& During playback
1
Press VFP.
The current VFP setting screen appears on the TV.
Ex.: When “NORMAL” is selected.
2
Press cursor 3/2 repeatedly to
select the VFP mode.
• Each time you press the button, the VFP
mode changes as follows:
NORMAL “ CINEMA “ USER1 “ USER2 “ (back
to the beginning)
NORMAL Normally select this.
CINEMA Suitable for a movie source.
USER1/USER2 You can adjust parameters that affect the
appearance of picture and can store the
settings (see below).
To turn off the VFP setting screen
Press VFP.
If no operations are done for about 10 seconds
The VFP setting screen disappears.
To adjust the appearance of the picture
You can adjust the appearance of picture and store in “USER1” and
“USER2.”
1
Press VFP, then press cursor
3/2 repeatedly to
select “USER1” or “USER2.”
Ex.: When “USER1” is selected.
OFF
NORMAL
GAMMA
BRIGHTNESS
CONTRAST
SATURATION
TINT
SHARPNESS
+0
+0
+0
+0
+0
3 GAMMA
3 GAMMA
Advanced Disc Operations
(Continued)
EN24-34_UX-J99DVD[UB]5.p65 03.12.12, 11:04 PM 33