Icom IC-7000 - Manual (Page 82)

73
5
FUNCTIONS FOR RECEIVE
DCenter mode
Displays signals around the displayed frequency
within the selected span. The set frequency is always
displayed at the center of the screen.
qSet a mode and frequency.
wSelect G - 1 (Scope).
ePush [F-3 FIX] momentarily to select the center
mode.
• “ =” appears when the center mode is selected.
rPush [F-4 SPD] momentarily to select the sweep
speed.
• “ ≈” or “≈≈” appears when Slow speed or Fast speed is
selected, respectively.
tPush [F-1 SPN] one or more times to select the
desired steps.
• ±10, 25, 50, 100 and 250 kHz are available.
• Push and hold [F-1 SPN] for 1 sec. to select the ±10
kHz step.
• The simple band scope operates in the peak level hold
mode. Peak levels are displayed in the background of
the current spectrum in a different color until the receive
frequency changes. This can be cleared by pushing
and holding
[F-2 HLD] for 1 sec., or deactivated in the
scope set m ode. (below)
yPush [F-2 HLD] to freeze the current spectrum dis-
play and range.
• “ H” and readout frequency indicator appear while the
function is in use.
NOTE: If there is a lot of signal noise, turn the pre-
amp OFF and the attenuator ON (p. 74) to reduce
the input level and improve the readability of the
scope.
[MENU/GRP]
[F-1]
[F-2] [F-3] [F-4]
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group G (Graphic).
• Push [MENU/GRP] momentarily one or more times to
select the menu G - 1 (Scope).
DScope set mode
This set mode is used to set the peak hold function
and scope size setting.
qSelect G - 1 (Scope).
wPush and hold [F-4 SPD] for 1 sec. to enter the
scope set mode.
ePush [F-1 ≤]
or
[F-2 ≥]
to select the desired set
item.
rSet the desired condition using [DIAL].
• Push [F-4 DEF] for 1 sec. to select a default condition.
tPush [Z(
MENU / GRP
)] to exit from set mode.
[MENU/GRP] [F-1] [F-2] [F-4] [DIAL]
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group G (Graphic).
• Push [MENU/GRP] momentarily one or more times to
select the menu G - 1 (Scope).