Icom IC-7000 - Manual (Page 50)

41
4
RECEIVE AND TRANSMIT
■Operating CW
qConnect a paddle or straight key as on page 22.
wPush [ Y(
BAND
)]/[ Z(
BAND
)] to select the desired
band or push a band key on the HM-151 .
e P ush [MODE] momentarily to select CW mode.
• After CW mode is selected, push [MODE] for 1 sec. to
toggle between CW and CW-R modes.
rRotate [DIAL] to tune in a desired signal with the
desired tone frequency.
tRotate [AF] to set audio to a comfortable listening
level.
ySet CW break-in operation as semi break-in, full
break-in or OFF.
• Push [F-1 BRK] one or more times to select the CW
break-in operation.
• “ ,” “ , ” and “OFF (no indication)” appears.
➧BK-IN: semi break-in
➧F-BK : full break-in
➧OFF : no break-in (ACC socket connection is neces-
sary as shown on page 22.)
uSet the CW delay time when semi break-in opera-
tion is selected.
• Push [F-1 BRK] for 1 sec. to enter the break-in delay
time set mode.
• Rotate [DIAL] to set the desired delay time.
iSet CW setting in the keyer set mode (S - 1).
• Push [F-2 KEY], [ Z(
MENU / GRP
)], then [F-4 SET] to
enter the keyer set mode. (p. 49)
oKeying to transmit, use the electric keyer or paddle
to send your CW signals.
• [TX] indicator lights red.
• The Po meter indicates transmitted CW signal strength.
!0Stop keying to return to receive.
Delay time of 7.5 dots is selected
for semi break-in operation.
Semi break-in operation is selected.
Appears
“CW” or “CW-R” appears
[ Y]
[ Z]
[DIAL]
[MODE] [AF] [TX] indicator
[MENU/GRP] [F-4] [F-1] [F-2]
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group S.
• Push [MENU/GRP] momentarily one or more times to
select the menu S - 1.
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group M.
• Push [MENU/GRP] momentarily one or more times to
select the menu M - 3.