Icom IC-7000 - Manual (Page 34)

3
25
BASIC OPERATION
■When first applying power (CPU resetting)
Before first applying power, make sure all connec-
tions required for your system are complete by refer-
ring to Chapter 2. Then, reset the transceiver using
the following procedure.
Resetting CLEARS all programmed contents in
memory channels and returns programmed values
in set mode.
q Make sure the transceiver power is OFF.
wWhile pushing [Y(
BAND
)] and [ Z(
BAND
)], push
[PWR] for 1 sec. to start resetting.
• The internal CPU is reset.
• The display changes to ‘ALL CLEAR,’ ‘RF power 100%’
and ‘Initial frequency and Mode’ as shown at right.
The transceiver’s
initial frequency and mode
[PWR]
[ Y]
[ Z]
[RF/SQL]: Center
[LOCK]: OFF
[POWER]: OFF
[AF]: Max. CCW
[PBT]: Center
(Push and hold for 1 sec.)
[PBT/M-ch/RIT]: PBT
(indicator lights)
CCW : counterclockwise
DMenu resetting (M - 1 )
Turn power ON, then check the display. If any of the
following indicators appear, turn them OFF as follows:
• Tuning step indicators, Z , (SSB, CW or RTTY):
Push [TS].
• MHz tuning step indicator, Z , (FM, WFM or AM):
Push [TS]
• 1 Hz frequency readout (SSB, CW or RTTY):
Push and hold [TS].
• Preamp indicator, :
Push [P.AMP/ATT]
• Attenuator indicator, :
Push [P.AMP/ATT]
• Noise blanker indicator, :
Push [NB/ADJ]
• Noise reduction indicator, :
Push [NR/LEV]
• Manual notch indicator, :
Push [MNF/ADJ]
• Auto notch indicator, :
Push [ANF/ •REC]
• Memory mode indicator, MEMO:
Use [F-4 V/M] in the M-2 menu (p. 27).
• Split indicator, :
Use [F-1 SPL] in the M-1 menu (p. 91).
If you can’t figure out how to return to the menu M - 1:
While pushing either [ Y (
MENU / GRP
) ] or [ Z
(
MENU / GRP
) ], turn power ON.
• The other groups are also reset to S - 1 or G - 1(Scope) in
this time.
[PWR]
[MENU/GRP]
After resetting the transceiver, set controls and
switches as shown in the diagram below.
■Initial settings