Icom IC-7000 - Manual (Page 17)

8
1
PANEL DESCRIPTION
1
DMenu S-3 functions
MEMORY WR ITE (pgs. 103, 104)
Push and hold for 1 sec. to store the dis-
played VFO frequency and operating
mode into the selected memory channel.
MEMO PAD WRI TE (p. 111)
Push to store the displayed VFO fre-
quency
and operating mode into a memo
pad.
MEMO PAD REA D (p. 112)
Push to call up a memo pad.
✔ What is the memo pad function?
The memo pad function stores the frequency and operating
mode for easy recall. The memo pads are separate from the
usual memory channels. The default number of memo pads
is 5, however, this can be increased to 10 in the miscella-
neous (others) set mode, if desired. (p. 134)
DMenu G-1 (Scope) functions
SWEEP STEP S (pgs. 72, 73)
➥Push mome
ntarily to change the sweep
step size.
• Available steps are ±10, 25, 50, 100 and 250
kHz.
➥P ush and hold for 1 sec. to change the
sweep steps to ±10 kHz.
PEAK HOLD (pgs. 72, 73)
➥Push to freeze the current simple band
scope display.
• “ H” indicator appears while the function is in
use.
➥Push and hold for 1 sec. to clear the peak
levels.
• Peak levels are displayed in the background
on the simple band scope display. The peak
hold function can be disabled in the
scope
set mode. (p. 73)
FIX/CENTER SELECTION (pgs. 72, 73)
➥Push to toggle the simple band scope fix
mode and center mode.
• Fix mode:
Rotating [DIAL] leaves the marker centered.
• Center mode:
Rotating [DIAL] moves the edge frequencies.
➥While fix mode operation, push and hold
for 1 sec. to set the displayed frequency
to that of the marker.
SWEEP SPEED
➥P ush momentarily to change the sweep
speed between Fast and Slow. (pgs. 72,
73)
➥Push and hold for 1 sec. to enter the
scope set mode. (p. 73)
F-4
SPD
F-3
FIX
F-2
HLD
F-1
SPN
F-1 F-2 F-3 F-4
SPN HLD FIX SPD
F-3
MPR
F-2
MPW
F-1
MW
F-1 F-2 F-3 F-4
MW MPW MPR