Integra DTR-8.4 - Manual (Page 95)

95
Using the Remote Controller with Other Components —Continued
Running Macros
Programmed macros can be run as follows.
Naming Macros
You can name your macros as follows. Names may con-
tain of up to five characters.
1 Press the [Macro] button.
2 Roll the scroll wheel to select the
macro’s number, and then press
the scroll wheel.
The actions in the macro are performed
in the order in which they were pro-
grammed.
1 Press and hold the [Custom] but-
ton for more than three seconds.
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
“MACRO,” and then press the
scroll wheel.
3 Roll the scroll wheel to select
“NAME,” and then press the
scroll wheel.
4 Roll the scroll wheel to select the
number of the macro that you
want to name, and then press the
scroll wheel.
5 Roll the scroll wheel to select a
character, and then press the
scroll wheel to set it.
The following characters are available.
6 Repeat step 5 until you’ve
entered all 5 characters.
The previous menu reappears.
If the name you are entering consists of
less than five characters, enter spaces at
the end to make it up to five.
Macro #1 selected
1st character
Macro #1 selected
1st character set
0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J
K L M N O P Q R S T U V W X Y Z + –
= < > _ / * space
_