Integra DTR-8.4 - Manual (Page 38)

38
Connecting the DTR-8.4 —Continued
Note:
Turning on the DTR-8.4 may cause a momentary power surge that might interfere with other electrical equipment on
the same circuit. If this is a problem, plug the DTR-8.4 into a different branch circuit.
The DTR-8.4 must be in Standby mode for the following procedure to work.
Note:
• Any components connected via will also be turned on when the remote controller’s [On] button is pressed again.
Turning On the DTR-8.4
1 Press the [Standby/On] button to turn on the DTR-8.4.
The display lights up and the Standby indicator goes off.
Press the Standby/On button again to enter Standby.
Turning On the DTR-8.4 with the Remote Controller
1 Press the scroll wheel.
“AMP” appears on the remote controller’s display. This is the mode for controlling the
DTR-8.4.
2 Press the [On] button to turn on the DTR-8.4.
To set the DTR-8.4 to Standby, press the [Standby] button.
Display Audio Selector
Direct/ Pure Audio
Master Volume Standby/On
Video 1 Video 3 Tape Tuner Phono Net Audio CD DVD Video 2
VCR 1 VCR 2
Video 4 Video 5
Zone 2 ( ) GRN Rec ( ) RED
Pure Audio psampling U
Standby
Push To Open
DTR-8.4
1
Standby/On
1
2