Integra DTR-8.4 - Manual (Page 106)

Attaching the Speaker Labels
The DTR-8.4’s positive (+) speaker terminals are color-
coded for ease of identification. (The negative (–)
speaker terminals are all black.)
The supplied speaker labels are also color-coded and you
should attach them to the positive (+) side of each
speaker cable in accordance with the above table. All
you need to do then is to match the color of each label to
the corresponding speaker terminal.
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals.
Connecting Your Speakers
Speaker terminal Color
Front left White
Front right Red
Center Green
Surround left Blue
Surround right Gray
Surround back/Zone 2 left Brown
Surround back/Zone 2 right Tan
1 Strip about 5/8" (15 mm)
of insulation from the
ends of the speaker
cables, and twist the bare
wires tightly, as shown.
2 Unscrew the terminal.
3 Fully insert the bare
wires.
4 Screw the terminal tight.
5/8" (15 mm)
DTR-8.4
FM
75
OUT
OUT
OUT
OUT
L
PHONO
PRE OUT
FRONT
SUB
SURR
R L
AUDIO R L
CD
TAPE
R L
AUDIO VIDEO S VIDEO
MONITOR OUT
R L
IN
IN
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO AUDIO VIDEO S VIDEO
GND
SURR BACK/ ZONE 2
R L IN
AC INLET
R
CENTER
ETHERNET
(Net -Tune)
R L
MULTI CH
INPUT FRONT
SUB
SURR
SURR
BACK
CENTER
R L
AM
ANTENNA COMPONENT VIDEO
Y
PB
PR
OUTPUT
INPUT 1
Y
PB
PR
INPUT 2
Y
PB
PR
SURR
BACK/
ZONE 2
SPEAKERS
FRONT SPEAKERS
L R L R
SURR SPEAKERS
CENTER
SPEAKER
R L
AC OUTLETS
AV RECEIVER MODEL NO. DTR-8.4
RATING: AC 120 V 60 Hz 9.0 A
AC 120 V 60 Hz SWITCHED
TOTAL 120W 1A MAX.
I R
IN
ZONE 2
REMOTE
CONTROL
A
B
RS232
OUT
12 V
TRIGGER OUT
DIGITAL IN
DIGITAL OUT
OPT
OPT
2
1
2
3
4
1
2
1
3
COAX
LINE INPUT
LINE INPUT
PRE OUT
SUB
Surround
back left
speaker
Surround
back right
speaker
Front left
speaker
Front right
speaker
Center
speaker
Surround
right
speaker
Surround
left
speaker
Powered
subwoofer
If your subwoofer is unpowered and you’re
using an external amp, connect the PRE OUT
SUB output to the amp’s input.
2