Integra DTR-8.4 - Manual (Page 47)

47
Basic Setup —Continued
Component Video Setup
This section explains how to assign the component video
inputs to input sources. You only need to change this set-
ting if you connect a video component to a component
video input other than the default assignment listed in the
following table, or if you want to output composite video
or S-Video sources from the component video output.
There are no other reasons to change these assignments.
Notes:
• If you select Last Valid, the video source remains the
same when you select another input source. For exam-
ple, if you set the VIDEO 1 input source to Last Valid,
then select the DVD input source, then select the
VIDEO 1 input source, you can watch a DVD while
listening to the audio from the component connected
to the VIDEO 1 audio inputs.
• This procedure can also be performed by using the
input selector buttons, [Setup] button, [ ]/[ ]/[ ]/
[ ] buttons, and [Enter] button.
Input source
Analog audio
input (fixed)
Component
video inputs
DVD DVD INPUT1
VIDEO 1 VIDEO 1 INPUT2
VIDEO 2 VIDEO 2 INPUT2
VIDEO 3 VIDEO 3 INPUT2
VIDEO 4 VIDEO 4 INPUT2
VIDEO 5 VIDEO 5 INPUT2
TAPE TAPE Last Valid
TUNER TUNER Last Valid
PHONO PHONO Last Valid
CD CD Last Valid
NET AUDIO NET AUDIO Last Valid
1 Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to assign.
2 Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
3 Use the Up/Down [ ]/[ ] but-
tons to select “2. Input Setup,”
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4 Use the Up/Down [ ]/[ ] but-
tons to select “3. Video Setup,”
and then press the [Enter] but-
ton.
The Video Setup menu appears.
5 Use the Up/Down [ ]/[ ] but-
tons to select “b. Component
Video,” and then use the Left/
Right [
]/[ ] buttons to select:
INPUT1: Select if the video compo-
nent is connected to COM-
PONENT VIDEO INPUT
1.
INPUT2: Select if the video compo-
nent is connected to COM-
PONENT VIDEO INPUT
2.
VIDEO: Select this to output com-
posite and S-Video
sources from the COM-
PONENT VIDEO OUT-
PUT.
Last Valid: Select this for audio-only
components.
None: Select this if you want no
video to be output when
the input source is
selected.
6 Press the [Setup] button.
The setup menu closes.
Advanced Menu
2.Input Setup
2-3.Video Setup
a.Video
:DVD
b.Component Video
:INPUT1
Quit:|SETUP|
Input:DVD
Input:DVD