beautypg.com

Integra DTR-8.4 User Manual

Page 64

background image

64

Advanced Operation

—Continued

Selecting the Multichannel Input

This section explains how to select the multichannel ana-
log input for playback.

Notes:

• This procedure can also be performed by using the

DTR-8.4’s input selector buttons and [Audio Selector]
button.

• You can only use the Direct and Pure Audio listening

modes with the multichannel input. If another listen-

ing mode is being used when the multichannel input is
selected, that listening mode is cancelled.

• Press the [Surround] button to adjust a bass and treble

effect (“Tone On” appears on the display).

Adjusting the Volume of Individual

Speakers for the Multichannel Input

While using the multichannel input, you can adjust the
volume of each speaker individually.

Note:

• You cannot select speakers that are set to No or None

on the Speaker Configuration menu (see page 41).

• These settings are not the same as the level calibration

settings on page 44.

• These settings affect only the multichannel input

source and have no effect on other input sources.

1

Press the [Input] button, and then
roll the scroll wheel to select
“DVD.”

2

Press the scroll wheel, and then
press the [Audio SEL] button
repeatedly to select “Multich. ”

3

Start playback on your DVD
player.

4

To adjust the volume, use the
Master Volume control, or the
remote controller’s [VOL] button.

The volume can be set from 0 to 100.

1, 2

1

4

2

1

Press the scroll wheel, and then
use the [CH SEL] button to select
each speaker.

Speakers are selected in the following
order.

2

Use the [Level–] and [Level+] but-
tons to adjust the volume.

The volume can be adjusted from –12
to +12 dB in 1 dB steps (–30 to +12 dB
for the subwoofer).

1

1

2

Front left

Center

Front right

Surr right

Surr back

right

Surr back

left

Surr left

Subwoofer