Integra DTR-8.4 - Manual (Page 68)

68
Advanced Setup —Continued
■ f. D.F. Mono
With this setting you can specify the listening mode to be
used when a mono digital audio signal is played (DVD,
etc).
Only listening modes that can be used with mono PCM,
Dolby Digital, or DTS can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
Notes:
• The b, c, d, e, and f settings are available only when an
digital audio input is assigned to the selected input
source.
• You can select other listening modes during playback
(see page 59), however, the listening mode assigned
here will be resumed after the DTR-8.4 has been set to
Standby.
Assigning the A & B 12V Trigger Outputs
This section explains how to assign input sources to the
12V TRIGGER OUT A and B outputs.
This section explains the audio and listening mode set-
tings you can use to tailor the sound as you like.
1 Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to assign.
2 Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
3 Use the Up/Down [ ]/[ ] but-
tons to select “2. Input Setup,”
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4 Use the Up/Down [ ]/[ ] but-
tons to select 7. 12V Trigger
Setup, and then press the [Enter]
button.
The 12V Trigger Setup menu appears.
5 Use the Up/Down [ ]/[ ] but-
tons to select a. Trigger A or b.
Trigger B, and use the Left/Right
[
]/[ ] buttons to select:
On: Trigger output active while
input source selected.
Off: Trigger output not active
while input source selected.
6 Press the [Setup] button.
The setup menu closes.
Audio Adjust Functions
1 Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
2 Use the Up/Down [ ]/[ ] but-
tons to select “3. Audio Adjust,”
and then press the [Enter] but-
ton.
The Audio Adjust menu appears.
Advanced Menu
2.Input Setup
2-7.12V Trigger Setup
a.Trigger A :On
b.Trigger B :Off
Quit:|SETUP|
Input:DVD
Input:DVD