beautypg.com

Basic setup —continued – Integra DTR-8.4 User Manual

Page 42

background image

42

Basic Setup

—Continued

Crossover Frequency

Notes:

• If the crossover frequency is set to a low value, and the

program material doesn’t contain any sounds that are
below that frequency, accordingly, the subwoofer will
not output much sound.

• This procedure can also be performed by using the

DTR-8.4’s [Setup] button, [

]/[

]/[

]/[

] but-

tons, and [Enter] button.

7

Use the Up/Down [

]/[

] but-

tons to select “d. Surround,” and
then use the Left/Right [

]/[

]

buttons to select:

Small:

Select if the surround left and
right speakers are small.

Large:

Select if the surround left and
right speakers are large.

None:

Select if no surround left and
right speakers are connected.

Note:

• If the Front setting in step 5 is set to

Small, the Large option cannot be
selected.

8

Use the Up/Down [

]/[

] but-

tons to select “e. Surr Back,” and
then use the Left/Right [

]/[

]

buttons to select:

Small:

Select if the surround back

left and right speakers are
small.

Large:

Select if the surround back

left and right speakers are
large.

None:

Select if no surround back left

and right speakers are con-
nected.

Notes:

• If the Surround setting in step 7 is set

to None, this setting cannot be
selected.

• If the Surround setting in step 7 is set

to Small, this setting cannot be set to
Large.

• If the Surr Back/Zone2 setting is set

to Zone 2, this setting cannot be
selected (see page 86).

Continue with step 9 in the right col-
umn.

9

Use the Up/Down [

]/[

] but-

tons to select “f. Crossover,” and
then use the Left/Right [

]/[

]

buttons to select a crossover fre-
quency.

Choose a crossover frequency suitable
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.

If you’re using THX-certified speakers,
select 80 (THX).

10

Press the [Setup] button.

The setup menu closes.

Speaker cone

diameter

Crossover

frequency

Over 12 in.

(30 cm)

40Hz

8 to 12 in.

(20–30 cm)

60Hz

6-1/2 to 8 in.

(16–20 cm)

80Hz (THX)

5-1/4 to 6-1/2 in.

(13–16 cm)

100Hz

3-1/2 to 5-1/4 in.

(9–13 cm)

120Hz

Under 3-1/2 in.

(9 cm)

150Hz