Entering settings for your fax machine, Scan settings – Muratec MFX-1500E User Manual
Page 47
Beyond the Basics
2.1
The EasyStart feature guided you through the “just-gotta” settings on your machine.
In the next few pages, we’ll cover additional settings.
Scan settings
Four different settings tell your machine how to scan documents. The initial factory
settings are probably right for most applications, so try using them before changing
any of these settings:
• Primary resolution mode — Sets the resolution for your documents. Choose
either normal, fine, superfine (“S Fine” on the
LCD
) or grayscale mode (“Gray”).
• Primary contrast mode — Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
• Scanning width — Sets how wide an area your machine scans for each page.
Note: The primary settings you choose effect your fax activity only.
To set these modes:
1
Press /
PROGRAM
,
J
, 0, 1,
ENTER
. The
LCD
asks you to select a resolution:
2
Press or /
PROGRAM
until the mode you want appears. In this example,
we’ve chosen fine resolution.
3
Press
ENTER
to save the setting. The
LCD
asks you to select a contrast setting:
4
Press or /
PROGRAM
until the mode you want appears. In this example,
we’ve chosen light contrast.
5
Press
ENTER
to save the setting. The
LCD
asks you to select a scanning width:
For most uses, “
A
4” is the proper setting. It scans the central 8.2
″
of each page.
But for documents with an unusual width, you may want to use the “
B
4” and
“A3” settings, which scans the central 9.9
″
and 11.6
″
of each page. (See “
A
4,
B
4,
A
3” in the Glossary on page 3.17.)
6
Press or /
PROGRAM
until the mode you want appears. In this example,
we’ve chosen “
A
4”.
7
Press
ENTER
to save the setting.
By following the steps above, you’ve set your defaults for scanning. Before sending
documents, you can “override” these default scan settings for that transmission.
To override the default resolution and contrast settings before sending a document:
• Press
RESOLUTION
to change the resolution.
• Press
CONTRAST
to change the contrast.
Once your document is transmitted, your machine returns to its default settings.
Scan Width :A4
Program/Enter
Scan Width :A3
Program/Enter
Contrast :Light
Program/Enter
Contrast :Normal
Program/Enter
Primary :Fine
Program/Enter
Primary :Normal
Program/Enter
Entering settings for your fax machine