Muratec MFX-1500E - Manual (Page 34)

1.22
Getting started
Redialing
If your fax call fails, your machine automatically redials it. In this Auto Redial
mode, your fax automatically redials the number every few minutes (see “Changing
redial settings,” right column) until one of the following happens:
• It reaches the remote fax machine.
• It has attempted the number of redials programmed and has still not connected
(see “Changing redial settings,” right column).
While in the Auto Redial mode, the machine can continue to receive faxes and can
make as many as 99 fax transmissions.
Note: If you used either the speaker or a handset to dial the call, you must redial
manually (see below).
Note: If the last redial attempt fails, your machine may print (and/or display) error
messages. For more information, see pages 3.11.
Redialing manually
You can always redial calls manually. And you must redial manually if you used
either the monitor speaker or an optional handset to dial the failed call.
To redial a fax call manually without using the monitor speaker or an optional
handset:
1 Make sure the document is in the feeder and that the resolution and
contrast are set.
2 Press REDIAL / PAUSE , START .
To redial a fax call manually with the monitor speaker or an optional handset:
1 Make sure the document is in the feeder and that the resolution and
contrast are set.
2 Press MONITOR / CALL or lift the optional handset to get a dial tone.
3 Press REDIAL / PAUSE .
4 When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, use the optional handset to tell that
person you’re sending a fax. When you hear fax tones, press START .
To redial a voice call manually using the optional handset:
1 Lift the optional handset to get a dial tone.
2 Press REDIAL / PAUSE . When the other person answers, use the optional
handset to speak to that person.
Changing redial settings
It’s up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval). To program
the redial settings:
1 Press / PROGRAM , J , 0, 6, ENTER .
2 Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 15 redials. In this example, we’ve entered 03.
Important: Enter a leading zero when entering a quantity less than 10.
3 Press ENTER to save the setting.
4 The LCD now shows:
5 Use the numeric keypad to enter the length you want between redial
attempts. Choose from 1 to 5 minutes. In this example, we’ve chosen 4.
6 Press ENTER to save the setting.
Set Redial Interval
Inter. (1-5):4
Set Redial Interval
Inter. (1-5):1
Set # Of Redials
# (02-15):03
Set # Of Redials
# (02-15):02