Muratec MFX-1500E User Manual
Page 104
Beyond the Basics
4
Press or /
PROGRAM
until the mode you want appears. In this example,
we’ve chosen “Mode1.”
5
Press
ENTER
.
Autodialing while using the
PIN
mask
Note: The following instructions presume you understand how to set and use your
machine’s autodialer. If you need to review, see pages 2.7–2.15.
If you chose “Mode 1” — the
PIN
goes in
In Mode 1, before autodialing a number for the first time, you must add the
PIN
to
the stored one-touch key or speed-dial number. Here’s how:
1
Begin by creating or changing an entry in the autodialer. See pages 2.7–2.15
if necessary. While you’re setting this up, the machine asks you to enter the
PIN
. The
LCD
shows:
2
Use the numeric keypad to enter the four-digit passcode. Here, we’ll use our
sample passcode again.
3
Press
ENTER
. In our example, we’re setting speed-dial number 001:
4
Use the numeric keypad to enter the desired
PIN
, up to eight characters in
length.
5
Press
ENTER
to save the
PIN
.
Note: If you press
ENTER
without entering the
PIN
, the fax machine beeps,
indicates “Invalid Number” on the
LCD
and then returns to step 4.
Now you may autodial the number as usual.
Important: While in
PIN
Mode 1, any autodialer numbers you use must include
the
PIN
. This also applies to autodialer numbers used with batch
transmission (see pages 2.20–2.23) or programmable one-touch keys
(see pages 2.48–2.55).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission,
you must store the
PIN
access code for the remote unit within the appropri-
ate batch box.
If you chose “Mode 2” — as you autodial, load the code
In this mode, you don’t have to add the
PIN
to the autodialer setting. Instead, you
enter the
PIN
manually each time you autodial:
1
Dial the number as you normally would, using the autodialer. Here, we’ve
pushed one-touch key
A
. The machine now asks for the
PIN
:
2
Use the numeric keypad to enter the
PIN
.
3
Press
START
. Your machine dials the number.
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 2.20–2.23), you must store the
PIN
access code for the remote unit
within the appropriate batch box.
Dialing from the numeric keypad while using the
PIN
mask
If you’ve specified Mode 1 — use “star” power
1
Enter the phone number, then press the * (“star”) key and enter the
PIN
.
The
PIN
always goes last. For example, to dial 19725550911 with a
PIN
of
“123456”, enter 19725550911*123456:
2
Press
START
. The
PIN
disappears from the display, and your machine dials the
desired phone number.
Press Start
19725550911*123456
Enter PIN Number
1057_
Enter PIN Number
_
001:PIN Number
1057_
001:PIN Number
_
Set PIN Number
Enter Passcode :6296
Set PIN Number
Enter Passcode :****
PIN Mode :Mode1
Program/Enter
2.58