Muratec MFX-1500E - Manual (Page 36)

1.24
Getting started
Answering calls manually
In any reception mode, you can always answer calls manually if you have an
optional handset installed. Just pick it up, as you would if using a normal phone.
If you hear someone speaking to you, use your
optional handset to speak back.
If you hear fax tones (“beep — beep — beep”),
press
START and hang up the optional handset.
The fax machine will begin receiving a fax.
Note: Receiving this way disables “V.34” mode
so that the machine receives the fax in
normal
ITU - T Group 3 fashion. (See
page 3.20.)
Note: Don’t try to answer a call by pressing MONITOR / CALL . The monitor function
is for dialing only.
Answering fax calls using another phone, not the fax machine
If you have one phone line ringing to several phones in your office and you have an
optional handset attached to your fax, there’s no need to run to the fax machine to
answer every call. If you happen to answer a fax call while you’re at another
extension, put the handset down, but don’t hang up. Walk to the fax machine and
pick up the optional handset. Then press
START .
After you press START , hang up both the fax machine’s handset and the second
telephone’s handset. Because remote fax machines will wait several seconds to hear
reception tones from your unit, you have about 30 seconds to walk to your fax, pick
up the handset, and press
START .
Reception modes
Your fax machine has five different reception modes — Tel Ready, Fax Ready,
Fax/Tel Ready, Tel/Fax Ready and Ans/Fax Ready. We’ll explain each of these in
this section.
Tel Ready mode
Use it if: • You want to use the same line for both fax and phone calls
and
• On that line, you’re using at least one other phone which is not
connected to your fax machine
or
• You have an optional handset installed on your fax machine
In this mode: Your fax machine never answers calls automatically. You must
answer each call as described in “Answering calls manually” (this
page, left column).
To select Tel Ready:
1 Press COPY / FAX to change to the fax mode, if the machine isn’t the fax mode.
2 Press / PROGRAM , I , and then press ENTER six times. The LCD shows your
current default reception mode:
3 Press or / PROGRAM until the LCD shows:
4 Press ENTER to save the setting.
In the Tel ready mode, the AUTO ANSWER light is not lit.
Tel Ready
Program/Enter
Fax Ready
Program/Enter
Receiving faxes