Muratec MFX-1500E - Manual (Page 32)

1.20
Getting started
Sending a fax using the
FBS
1 If the machine is already in Fax mode, skip to step 2.
If the machine is in Copy mode, press
COPY / FAX to change to Fax mode.
2 If there isn’t a document in the feeder, skip to step 3.
If there’s a document in the feeder, remove it.
3 Open the book-cover.
4 Place the document face down on the FBS and align it with the document
scale on the right, then gently close the book-cover.
Make sure the document is set beyond the right front corner.
Important: Gently close the book-cover so that you don’t catch your hands,
possibly injuring them.
When a thick document, such as a book, is on the
FBS , do not
press strongly from the top of the book-cover. This may break
the contact glass and cause an injury.
5 Press BOOK DOC SIZE to select the document size, letter (displayed as Ltr),
legal (Legl), half-letter (HLtr) or B4. (Half-letter is 8.5
″
wide × 5.5
″
tall; B4,
widely used internationally, is 10.1 ″ × 14.3 ″ .)
6 Adjust resolution and contrast if necessary.
Press
RESOLUTION to change the resolution.
Press CONTRAST , then press or to change the contrast.
7 Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to “dial out” from an office telephone system, or 1 for
long-distance.)
8 Press START .
By pressing START , you’ve just given your machine a command. In turn, your
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the LCD for a few seconds:
You’ll need this command number to cancel the transmission or to print a
stored document (see pages 1.23).
Then your machine will scan the document into the memory.
While your machine scans the document, the
LCD will show:
9 When the scanning is done, the LCD will show:
If you want to send more pages, proceed to step 10.
Otherwise, press
START to start the transmission, and skip to step 11.
10 Place the next page, then press NEXT to start scanning.
Note: If necessary, select the document size (see step 5).
To send any more pages, repeat steps 9-10.
Otherwise, press
START to start the transmission, and skip to step 11.
Start Scan
→ →
Next
Tx Start
→ →
Start
919725552009
Ltr NextDoc Mem100%
== Command:01 ==
Press Start
919725552009_