FUJITSU DL6400 - Manual (Page 85)

Using Setup Mode
8-4 User’s Manual
Entering setup mode prints the <> menu.
Table 8-1 summarizes the setup mode functions.
To select a function from the <> menu, do the
following:
1. Repeatedly press LOCK to position the yellow arrow on the print
head beneath the required function.
2. Press FONT or MENU to select a function. If the function has
items and options, the printer prints the first item and its options.
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT GAP-ADJ
Table 8–1 Setup mode functions
Function Purpose
SAVE&END Exits setup mode and saves changes made in
setup mode.
MENU1 and
MENU2 Assigns print features to MENU1 and
MENU2 on the control panel.
HARDWRE Changes hardware options.
ADJUST Changes print adjustment options.
CONFIG Changes configuration options.
GAP-ADJ Sets the head gap, and is displayed when the
printer is equipped with the APTC function.
DEFAULT Resets MENU1 and MENU2 default values
set at shipment.
LIST Prints all currently selected options.
SELF-TST Run the self-test.
HEX-DUMP Prints hexadecimal data dumps.
V-ALMNT Checks and corrects vertical printing
alignment.
Using Setup
Mode
(GAP-ADJ is printed only with APTC installed.)
DL6400/6600 Book Page 4 Friday, July 31, 1998 11:42 AM