FUJITSU DL6400 - Manual (Page 108)

Changing Hardware Options
User’s Manual 8-27
SETUP MODE
Note:
Underlined options are the factory default settings.
To change printer hardware options, check that continuous forms are
loaded. Then do the following:
1. Enter setup mode.
Place the printer offline and then press FONT and MENU
simultaneously. Wait for the printer to stop printing and check that
the <> menu is printed.
2. Select HARDWRE.
Repeatedly press LOCK to position the yellow arrow on the print
head beneath HARDWRE. Press FONT to select HARDWRE and
print the first item and its options.
3. Select an option.
Press LOCK to move the yellow arrow to the option. Press FONT
to select the option and print the next item.
Important:
To print the previous item, press MENU.
IGNORE
DETECT The printer ignores CD.
The printer detects CD.
<==END==> Indicates the end of the HARDWRE item list. Press
FONT to print the first item, . Press
MENU to print the previous item, for a serial
interface or for a parallel interface. Press
ONLINE to reprint the <> menu.
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT GAP-ADJ
CNTONLY DETECT IGNORE
Table 8–4 HARDWRE options (Continued)
HARDWRE item Options Description
(GAP-ADJ is printed only with APTC installed.)
DL6400/6600 Book Page 27 Friday, July 31, 1998 11:42 AM