FUJITSU DL6400 User Manual
Page 115
Changing Configuration Options
8-34
User’s Manual
Note:
Underlined options are the factory defaults settings.
NOTE
SETUP
ALL
Lock function of setup mode.
Enables all buttons on the control panel.
Disables the setup-related buttons to keep the printer from
entering setup mode during the offline state.
Disables the setup-related buttons and the LOCK, FONT,
and MENU buttons.
DISABLE
ENABLE
Effectiveness of the Cut Sheet Feed Selection command
(//S//)
Makes the command ineffective.
Makes the command effective.
Note: The Cut Sheet Feed Selection command (//S//)
changes the paper source to the paper table and waits for
manual insertion of a cut sheet.
TRACTOR
EDGE
Detects the end of continuous forms.
Paper end is detected by the sensor.
Paper-end unprinted area:
Front feeding continuous forms: About 31 mm
Rear feeding continuous forms: About 88 mm
Regardless of paper end, printing continues near the edge
of paper.
Paper-end uprinted area:
Front feeding continuous forms: About 4.2 mm
Rear feeding continuous forms: About 8.5 mm
<==END==>
Indicates the end of the CONFIG item list. Press FONT
to print the first item,
print the previous item,
reprint the <
Table 8–6
CONFIG options (Continued)
CONFIG item
Options
Description
DL6400/6600 Book Page 34 Friday, July 31, 1998 11:42 AM