FUJITSU DL6400 - Manual (Page 69)

Continuous Forms
7-6 User’s Manual
The uncut dimension at C on each end of horizontal perforations
shown below must be 1 mm or more.
When a cross-point cut occurs at the juncture of vertical and horizontal
perforations, printing is inhibited in the shaded area shown in the
figure below. Printing is not allowed in this area to prevent damage to
forms and also to prevent printer faults.
Notice:
This restriction also applies when the print head moves without
printing.
3 mm (0.12 in)
cut
1 mm (0.04 in)
uncut
Vertical
perforations
C C
Vertical perforations (middle)
Horizontal perforations
Edge
Cut
1 mm (0.04 in) or more
Uncut
28 mm
(1.1 in) 28 mm
(1.1 in)
Cross-point uncut Cross-point cut
Inhibited area
3 mm
(0.12 in)
3 mm
(0.12 in)
Cross-point cut
☞
DL6400/6600 Book Page 6 Friday, July 31, 1998 11:42 AM