FUJITSU DL6400 - Manual (Page 37)

Loading Continuous Forms (Rear)
4-6 User’s Manual
Refer to the Rear-Feed Tractor User’s Manual for information on the
rear-feed tractor option.
Forms are cut at perforations 23.3 mm (11/12 inch) above the print
head center when the print head center is on the sixth line. A single line
feed is 4.2 mm (1/6 inch)..
1. Press the TEAR OFF button on the control panel. The continuous
forms are then automatically loaded to where they are to be cut.
For the operation of the printer with the LCD control panel, see
Appendix E.
2. Open the noise-proof cover.
3. Check that the perforations are at the paper cutter.
4. Cut the continuous forms as shown in the figure below.
Loading
Continuous
Forms (Rear)
Cutting
Continuous
Forms
23.3 mm
(11/12 in)
Print head center
Perforations
DL6400/6600 Book Page 6 Friday, July 31, 1998 11:42 AM