FUJITSU DL6400 - Manual (Page 238)

Messages
User’s Manual E-33
USING THE
LCD/LED TYPE
CONTROL PANEL
Messages indicating fatal errors
LED model
Generally, a user cannot clear errors caused by defective printer
hardware because usually, the printer does not restart. Therefore, when
a fatal error occurs, immediately call your repair service center. For
preliminary identification help of the fatal error types possible, please
read the information below.
If a fatal error occurs, the printer enters one of the following states:
• If printing is in progress, it is stopped immediately.
• The ONLINE indicator goes off, and the printer goes offline.
• The PAPER OUT indicator blinks, and the alarm buzzer sounds.
• One of the FONT LEDs light up, thus indirectly indicating the
alarm type (see table E-7 for the errors and their corresponding
LEDs.)
*1, *2 You can evade each of these errors using the corresponding
method indicated below:
*1 Confirm whether the specification of the form used lies within the
printer’s specification (for details see “Paper specification”).
*2 Set the Jam removal lever (for how to do it, see page 6-4).
Table E–7 Alarm names and the corresponding LED display
Alarm name LEDs lit
Power alarm
Left end alarm
Overload alarm
RAM alarm
FAN alarm
Head alarm
SP motor alarm
LF motor alarm
GAP alarm*1
Ribbon motor alarm
JAM lever alarm*2
CSF motor alarm COUR 10
PRESTG 12
COMPRESS 17
Bold PS
N. Sans PS
DRAFT 10
DRAFT 12
MENU FONT
COUR 10, COMPRESS 17
COUR 10, Bold PS
COUR 10, Time PS
COUR 10, N.Sans PS
#E_AppendixE Page 33 Wednesday, September 2, 1998 10:05 AM