Furuno FS-1570 - Manual (Page 143)

9 NBDP PREPARATIONS
9-5
9.3 Timer Programming
A built-in timer allows you to automatically receive and transmit files. 10 timer programs can
be registered.
9.3.1 Registering timer programs
1. Press the function key [F5]. Press the [2] key to display the Timer Operation Entry
screen.
Create
Change
Timer Operation Entry
Timer Operation List
Timer Operation Set Up
Operation :
Station :
Start Time : 00: 00: 00
Stop Time : 00: 00: 00
Receive/Send : Receive Send
File to Send :
Timer operation entry screen
2. If Create is not underlined, press [
→ ], [ ↑ ] and the [Enter] key to underline it.
3. Enter a suitable operation name on the Operation line. Any alphanumeric characters
may be used. See note 1 below.
4. Press the [ ↓ ] key to choose Station. Press the [ → ] key to display the Station List.
Choose a station and press the [Enter] key.
5. Press the [ ↓ ] key to choose Start Time. Enter start time in 24-hour notation. To have the
operation start at 8:35 a. m., for example, the keying sequence would be;
[0] [8] [3] [5] [0] [0]
6. Press the [ ↓ ] key to choose Stop Time. Enter stop time.
7. Press the [ ↓ ] key to choose Receive/Send. Choose operation category; Receive or
Send.
8. Insert a floppy disk in drive, press the [ ↓ ] key to choose File to Send, press the [ → ] key
to display the file list, choose a file, and press the [Enter] key.
9. Press the [Enter] key
10. Press the [Enter] key. The operation name appears in the Timer Operation List.
To register other timer operation, press the [
→ ] key to choose Create again and then press
the [Enter] key. Repeat steps 3-10.
Note 1:
If the operation name entered already exists, the display “Operation name already
exists. Press any key to escape.” Press any key and change the operation name.
Note 2:
If the station name entered has not been registered, the display shows “Station by
that name does not exists. Press any key to escape.” Press any key and register
the station as shown in paragraph 9.2.