Furuno FS-1570 - Manual (Page 141)

9 NBDP PREPARATIONS
9-3
9.2 Station List
The station list provides abbreviated dialing with storage for up to 50 stations, one
frequency pair (RX and TX) per station. For stations which have more than one frequency
pair, you might add a suffix to the station name to denote multiple frequency pairs. For
example, station name FURUNO followed by -1, -2, -3, etc. for each frequency pair
required.
9.2.1 Registering stations
1. Press the function key [F5] followed by the [1] key to show the Station Entry screen.
Station Entry
Create
Change
Station List
Station Set Up
Station :
ID Code :
Mode : ARQ FEC
CH/Table : Channel ScanTable
Num/Table:
Station entry screen
2. On the right-hand side of the screen, Create and Change are shown and Create should
be underlined. If it is not, underline it by pressing [ → ], [ ↑ ] and the [Enter] key.
3. The cursor is now choosing Station. Enter station name, using up to 18 characters.
4. Press the [
↓ ] key to choose ID Code. Enter station ID code.
5. Press the [ ↓ ] key to choose Mode. Choose communication mode with [←] or [ → ] among
the following:
ARQ: Automatic Retransmission Request
FEC:
Forward Error Correction
6. Press the [ ↓ ] key to choose CH/Table. Choose ScanTable or Channel as appropriate.
7. Press the [ ↓ ] key to choose Num/Table.
8. If you selected "Channel" at step 6, enter ITU channel number (see Appendix) or User
channel number.
If you selected "ScanTable" at step 6, press the [ → ] key to show scan group list registered.
Choose a scan group name by using the [ ↓ ] or [ ↑ ] key followed by pressing the [Enter] key.