Loading continuous forms (rear feed) – FUJITSU DL9300 User Manual
Page 78
User's Manual
Paper
Handling
PAPER HANDLING
3-21
10. Put the rear stacker in its down position.
11. Press the LOAD button to advance the paper to the top-of-form
position. Top-of-form is the first line on which printing can
start. After loading paper, the printer goes into online mode.
12. Print a sample page and check the page margins. Make the
following adjustments, as necessary:
• Horizontal alignment. Move the forms tractors as required.
• Top-of-form setting (see Chapter 5).
• Margin settings. Use your software or the printer setup
mode (see Chapter 5).
NOTE
Do not open the front cover during printing.
Loading Continuous Forms (Rear Feed)
A tractor is supplied as standard and is attached to the front of the
printer. It can be attached to the rear of the printer. You can also buy a
tractor unit as an additional rear tractor unit.
A maximum of 6-ply media can be fed from the rear tractor unit.
• Put the paper table in the normal mode when the rear tractor
unit is to be used.
To reinstall the tractor unit for rear feed:
1. Slide the rear stacker horizontally to remove it from the printer.