FUJITSU DL9300 User Manual
Page 124
Setup Mode
USING SETUP MODE
User's Manual
5-33
Table 5.5 ADJUST Items and Options
NOTE: Underlined options are the factory defaults.
Sets the top-of-form for continu-
ous forms in increments of 1/6
inch (4.2␣mm) from the physical
top of the page.
1/6 IN
The default is recommended if
:
your top margin is not software-
specified. A setting of 1/6 inch
6/6 IN
is preferable when your top
:
margin is software-specified.
66/6 IN
Fine-tunes the top-of-form
position for continuous forms.
0/180, ..., 29/180 Increases top-of-form in
increments of 1/180 inch
(0.14 mm).
Sets the top-of-form for single
sheets in increments of 1/6 inch
(4.2 mm) from the physical top
of the page.
1/6 IN
The default is recommended if
:
your top margin is not software-
6/6 IN
specified. A setting of 1/6 inch
:
is preferable when your top
66/6 IN
margin is software-specified.
Fine-tunes the top-of-form
position for single sheets.
0/180, ..., 29/180 Increases top-of-form in incre-
ments of 1/180 inch (0.14␣mm).
ADJUST
Items
Options
Description