FUJITSU DL9300 - Manual (Page 104)

Setup Mode
USING SETUP MODE
User's Manual 5-13
Table 5.2 Required Options (Cont.)
Function Item Option
HARDWRE FORMAT If you have a serial interface, the serial
BAUD-RT interface options selected on the printer
PROTOCL must be the same as the settings you
DSR selected using your software or your
DUPLEX computer operating system. If the
settings are not the same, the printer
will not print or will print garbage.
See the section Hardware Items and
Options
later in this chapter.
ADJUST None If you are not using software to specify
the top margin of the page, use the
printer’s default top-of-form setting, 1
inch (25.4 mm) from the top of the paper.
If you are using software to specify the
top margin of the page, change the
default setting to 1/6 inch (4.2 mm).
See the section Print Position Adjust-
ment Items and Options
later in this
chapter.
CONFIG None You can change the printer’s primary
configuration.
See the section Configuration Items
and Options
later in this chapter.
GAP-ADJ If you adjust the gap manually or fix
the gap, change the setting.
See the section Print Head Gap
Adjustment Items and Options.