FUJITSU DL9300 User Manual
Page 68
User's Manual
Paper
Handling
PAPER HANDLING
3-11
To load paper from the cut sheet feeder:
1. Make sure that the printer is turned on and continuous forms
are retracted to the park position. (For details, see the section
Unloading Continuous Forms
later in this chapter.)
2. Press the PAPER PATH button to select CUT SHEET (the
indicator lights).
3. Press the FRONT DIR button to select the direction of ejecting
cut sheets.
• Front ejection
FRONT indicator lights.
• Rear ejection
FRONT indicator doesn’t lights.
4. Prepare the feeder as follows:
Preparing the cut sheet feeder (Front)
• Lift up the paper table
• Attach the cut sheet feeder, locating it on the guide pins.
Adjust the letter A labeled on the cut sheet feeder to the
letter A labeled on the printer
• Put the paper table on the cut sheet feeder.
Guide pin